Did you know most cleaning companies use a one or two step cleaning process?
We use a 12 step cleaning process so you get a more thorough, longer lasting cleaning.
Providing carpet cleaning, area rug cleaning, upholstery cleaning, tile & grout cleaning and resealing, natural stone cleaning and resealing, and refinishing of hardwood floors in the Walla Walla Valley since 1998
Our 12 step cleaning process
Step 1: Pre-Inspection
We identify potentially permanent stains to give you a reasonable expectation of the final results.
Step 2: Commercial Pre-Vacuum
We pre-vacuum which allows us to remove 80% of the dry soil.
Step 3: Move Furniture
This step is optional. We can clean the traffic areas in your home without moving any furniture.
Step 4: Prepare
We lay down drop cloths to protect wood floors and we place corner guards at the main transitions to protect walls and trim.
Step 5: Pre-Spot
We pre-treat difficult stains to increase chance of removal.
Step 6: Pre-Spray
We apply a preconditioning agent to emulsify and break down the soil and oils. Then we agitate any areas that need extra attention.
Step 7: Clean
We run over the carpet with our rotary jet extractor. Then we do a dry stroke that allows us to recover up to 90% of the moisture we used.
Step 8: Post Spot
We re-treat and re-clean any areas that seem like we could make an additional improvement.
Step 9: Apply Protector
We apply Teflon protector and groom it in so it gets fully dispersed on all of the fibers.
Step 10: Post Groom
We rake out our footprints to make sure we didn’t miss anything and to set the pile so it will dry faster.
Step 11: Speed Dry
As we finish cleaning we set up our down draft air-mover. This takes the warmer, dryer ambient air and blows it down across the surface of the carpet so it usually dries to the touch in 8-12 hours.
Step 12: Post Cleaning Inspection
We make sure every area looks perfect, or as close to it as we can make it!